Description:
Here are 41 dynamic patches created for the Novation Circuit including a wide variety of pads, basses, leads, keys and SFX that are suitable for many genres.
This colection also contains the 'Magic Arp' patch.
They are stored both as individual patches and a bank of 41.
All of the Macro Knobs have been assigned useful, dynamic functions with the following helpful standardization:
Macro 1 - Filter Cutoff Frequency
Macro 2 - Filter Resonance
Macro 3 - Amp Release
Macro 4 - ?
Macro 5 - ?
Macro 6 - ?
Macro 7 - Chorus Level
Macro 8 - Distortion Level
Requirements:
To use these patches you will need a Novation Circuit and a computer that can send the SYSEX file to Circuit.
Terms & Conditions:
You are buying the right to use these patches. The patches are under the copyright of Lightfinger/Matthew Hurtgen and no one else has ownership. You are buying a license to use these patches in any musical way you choose. The license is only valid for the user/organisation who purchases it from Lightfinger/Matthew Hurtgen. If you give away or sell these patches, you are still the holder of the license, not the new user of the patches. Please do not give away these patches.
Returns:
Our refund policy is All Sales Final. Unfortunately we can’t offer you a refund or exchange after this period.
Shipping:
Our products are emailed within 24 Hours to the email address you used. You will also be sent a link to a download page. Please allow 30 minutes before contacting us if anything goes wrong with the download and remember to check your spam folder. If you need further assistance please email us at
[email protected].
Installation:
First, unzip the file 'Lightfinger Circuit Patches Vol1.zip' onto your hard drive and remember where you unzip them to.
Next, install the free Circuit Editor from Isotonik, found here: http://isotonikstudios.com/novation-x-isotonik/novation-circuit-editor/
Circuit has 64 available slots for patches. Saving a new patch onto Circuit will overwrite one of the 64 factory patches. You can always reload the factory patches onto Circuit.
LOADING A PATCH ONTO CIRCUIT
1. Connect Circuit to your computer via USB and power it on normally.
2. Open the Isotonik Circuit Editor. Under VIEW CONTROL select 120% which will expand the editor for easier viewing.
3. When properly connected, Circuit will appear in the top left corner of the Editor under MIDI PORT.
4. Click on the Load Single Patch From Disc and browse to directory where the patches were unzipped to.
5. Select a single patch. The patch is now loaded onto the resident memory of Circuit.
SAVING A PATCH ONTO CIRCUIT
1. Click on Upload Single Patch to Circuit.
2. From the pop-up window, select the slot where you wish to store the patch.
